Model T Ford front axle double wishbone clamp 11-18

Description

FRONT  AXLE DOUBLE WISHBONE CLAMP  1911-1918
This front axle double wishbone clamp is a reproduction of an accessory that was offered to add an additional  wishbone to the early style axle that has the wishbone on top of the axle, (1911-13).
This clamp exists of three parts.  Lower, middle, and upper sections.
See photo above
The clamp set is cast bronze and is supported together with a 3/8" bolt.
See photo above
See old photo above of the double wishbone on this home made speedster.
Complete installation diagram is included.
Made in U.S.A.
DOUBLE  RODS
We do not include any  rods with this clamp.
These rods must be fabricated to fit into place for your car.
We have given some examples of the different ways to construct your double wishbone.
See photo above
1) Use a late style wishbone and cut off the end ball at the desired length.
2) Use a 7/8" steel rod and fabricate an end hole and then cut it to the desired length.
3)  We offer a pair of late wishbone ends that can be welded to 7/8" steel rod and cut to length.
The late pair of wishbone rod ends are .00 a pair plus shipping.  These will be listed as a separate part in our store.
TIP;  Replace spring perch nut with drive shaft pinion nut.  They are thin so a cotter pin can be used.